A short overall length means that the MK-Z series is versatile in mounting. Auto switches can be mounted on any of the 4 surfaces with no projection of the switch. Rotary clamp cylinder w/auto switch mounting grooves. Bore sizes (mm): 12, 16, 20, 25, 32, 40, 50, 63. Standard stroke (mm): 10, 20, 30, 50 (depending on bore size) Disconnect one of the two wires from the pressure switch. Connect it to one end of your jumper wire. Turn on the furnace. Once you hear the draft inducer startup, you’re good to proceed. Connect the other end of the jumper wire to the other wire on the pressure switch. Let it run for a few minutes. IS10E Pressure Switch with Female Pipe Adapter, AC/DC, Analog Indicator. ISE10E is a pressure switch with a linear mechanical set point indicator, for modular installation with SMC's FRL units. The switch housing attaches to a threaded block for mounting inline with the FRL. The housing assembly includes a reed switch activated by a piston Low Differential Pressure Sensor. Voltage output: 1 to 5 V. PSE550 . The intended use of thepressure sensor is to measure the pressure of fluids and provide an analogue output signal. 1 Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of etting Pressure t Switch turns ON when the pressure is larger than setting pressure. Switch turns ON when the pressure is smaller than setting pressure. M P a (k P a) ON OFF ON OFF 0.4 (0) 0.2 (-50) 0 (-100)-0.1 PS1000 PS1100 PS1200 Model PS1000 PS1100 PS1200 ±3% F.S. Switch Specifications The value in the brackets is forPS 1200. H i g h V a c C2lW22.

cara setting pressure switch smc